Power up your Slash Plus, and test the newly installed LCD.ĩ. Remove the protective film on the replacement LCD.Ĩ. Insert the LCD cable into the hatch, close the hatch.ħ.

Locate the positioner on the LCD cable.Ħ. Push the new LCD cable through the hole of the cooling module, slide the metal portion of the new LCD through the slot, align and stick the metal portion on the cooling module.ĥ. Cut the fresh double-sided into three sections (10mm wide), adhere them onto the metal part of the new LCD module.Ĥ. Lift off the double-sided tape beneath the old LCD, Peel the old LCD from the cooling module.ģ. Remove the damaged/deprecated LCD: Begin by peeling off the old LCD tape from the right-bottom sides, Open the LCD cable hatch, and remove the LCD cable.Ģ. Please make sure to discharge yourself of any static electricity and that you are well grounded before handling the LCD screen.ġ. Note: The LCD screen is highly sensitive to static electricity.

(1) Double sided screen tape (not included).

In the event your existing LCD module gets damaged or needs to be replaced, please use the following steps: HOW TO INSTALL THE REPLACEMENT LCD MODULE Based on typical usage, this LCD Module will last roughly 10,000 print hours. To get the most out of your Uniz Slash Plus and to keep the machine in optimal condition, it’s best to have a spare LCD Module on hand. KEEP YOUR SLASH PLUS IN OPTIMAL CONDITIONĪt some point during your resin-based 3D printing experience, the LCD Module and other consumables will wear out and require replacing.

Uniz slash plus 3d printer